Industrial Sprocket Diameter Formula

With the rapid development of industry, Industrial Sprocket is not a small part, but as production needs become very important, it is necessary to maintain it properly after using Industrial Sprocket. Following is China Industrial Sprocket manufacturers will take a look:
1. The tightness of the sprocket should be appropriate. If it is too tight, it will increase power consumption and the bearing is easy to wear; if it is too loose, the sprocket is easy to jump and off the chain. The tightness of the sprocket is: lifted or pressed from the middle of the sprocket, about 2% -3% of the center distance between the two sprockets.
2. There should be no swing and skew on the sprocket mounted on the shaft. In the same transmission assembly, the end faces of the two sprockets should be in the same plane. When the center distance of the sprocket is below 0.5 meters, it can deviate by 1 mm; when the center distance of the sprocket is above 0.5 meters, it can deviate by 2 mm. However, there should be no side phenomenon of friction sprocket teeth. If the two wheels are deviated too much, it is easy to produce off-chain and accelerated wear. When replacing the sprocket, care must be taken to check and adjust the offset.

So in addition to maintaining Industrial Sprocket well, hzqjchain Industrial Sprocket manufacturers also share the formula of Industrial Sprocket diameter
1. Sprocket indexing circle diameter: d = p / sin (180 ° / z) p = pitch check table z = number of teeth.
2. Sprocket tooth tip circle (outer diameter): D = p × (0.54 + cot180 ° / z).

information about Industrial Sprocket : https://www.hzqjchain.com/