Under normal circumstances, the driven sprocket in the traditional sprocket is installed on the drive wheel under the requirements of the standard, that is, the transmission method of the chain is used to bring the transmission of the drive wheel, and under normal circumstances, it is active Compared with the driven sprocket, the sprocket is relatively small in terms of the size, so that the purpose of reducing its own speed can be achieved through this method, and at the same time, the effect of increasing the torque can be more obvious. .
China Drive Chain Wholesaler introduced that the new sprocket is too long or stretched after use, which is difficult to adjust. You can remove the chain link depending on the situation, but it must be an even number. The chain link should pass through the back of the sprocket, the lock piece should be inserted outside, and the opening of the lock piece should face the opposite direction of rotation. The sprocket should be filled with lubricating oil in time during work. The lubricating oil must enter the matching gap between the roller and the inner sleeve to improve working conditions and reduce wear. The old sprocket cannot be mixed with some new sprocket, otherwise it is easy to produce impact in the transmission and break the sprocket. When the machine is stored for a long time, the sprocket should be removed and cleaned with kerosene or diesel oil, and then coated with oil or butter and stored in a dry place.
Through the above introduction, Roller Chains Exporter hopes that you can simply refer to the content of this article in future use.
コメント